Ultra-Kill Weed & Grass Killer

Weed & Grass Killer, Concentrate

Weight: 128 fl oz (1 gl) 3.7 lt

Directions

Read and follow label instructions. Mixing: For best results use 2-1/2 fl oz (5 tbsp) per gallon of water. One gallon of water will treat approximately 300 square feet. It is a violation of Federal law to use this product in a manner inconsistent with its labeling. Note: see the consumer information section of this label for important information on protecting plants you like. When to apply: Apply to actively growing weeds, preferably before the seed heads form. Completely spray the foliage of the weeds and grasses you want to kill until thoroughly wet. It's best to apply on a warm, sunny day when daytime temperatures are above 60 degrees F. Weed control is accelerated by warm, sunny weather. Apply when the wind is calm. Rain or watering two hours after application will not wash away effectiveness. Most treated weeds usually show initial symptoms in two to four days and complete kill in one to two weeks. Hard-to-control weeds may require a second application if not completely dead in four weeks. How to Apply: This product is formulated for spot treatment of individual weeds and grasses or for treatment of large areas as instructed on this label (see specific site areas). Apply with a plastic, aluminum or stainless steel tank-type sprayer. Do not apply with galvanized or unlined steel sprayer, or through any irrigation system or sprinkling can. Use a tank-type sprayer with a coarse spray nozzle for spot treatments. Use a hose-end sprayer to treat large areas such as for lawn renovation or to prepare sites for planting flower beds or vegetable gardens. Apply to evenly and thoroughly wet weeds and grasses. Apply using any of the following equipment: plastic, aluminum or stainless steel tank sprayer; a hose-end sprayer recommended for weed killers; hand-trigger pump sprayer. Cleaning application equipment: to clean sprayer after use, triple rinse sprayer and all sprayer parts with water. Spray rinse water on bare soil or gravel. After thorough cleaning, sprayer can be used for other products. Use the following table to determine the amount of Ultra-Kill Weed & Grass Killer Concentrate to mix with water. Close cap tightly after use. No need to rinse cap. 1 teaspoon (tsp); 1 tablespoon (tbsp) = 3 tsp; 1 fl oz (2 tbsp); 2 fl oz (4 tbsp). Applicator; Mixing Instructions General Weed Control (annuals and seedling weeds); Mixing Instructions Tough Weed Control (perennials, brush or lawn renovation); Area to Treat: tank sprayer; use 1-1/2 oz (3 tbsp) of product in 1 gallon of water; Use 2-1/2 oz (5 tbsp) of product in 1 gallon of water; 300 sq ft (30 x 10 ft) or use for spot treatments. Hose-end sprayer; add 1-1/2 oz (3 tbsp) of product into sprayer jar. Do not add water. Set dial to 1-1/2 oz and spray; add 2-1/2 oz (5 tbsp) of product to sprayer jar. Do not add water. Set dial to 2-1/2 oz and spray. 300 sq ft (30 x 10 ft). 6 gallon hose-end sprayer; add 6 oz (12 tbsp) of product to sprayer jar. Fill to the 4 gallon mark and spray; add 10 oz (20 tbsp) of product to sprayer jar. Fill to the 4 gallon mark and spray; 1,200 sq ft (30 x 40 ft). Hand trigger sprayers 24 oz capacity; use 2 tsp in 24 oz of water; use 1 tbsp in 24 oz of water; use for spot treatments or apply to single weeds. Hand trigger sprayers 32 oz capacity; use 2-2/3 tsp in 32 oz of water; use 1-1/3 tbsp in 32 oz of water; use for spot treatments or apply to single weeds. This product can be used to refill Ultra-Kill Ready-to-Use Weed & Grass Killer, following mixing directions on the label. Use the mixed solution within two weeks. Where to use: General weed control: Use near fences, in paths, patios, sidewalks, curbs and driveways; around ornamental trees, shrubs, flower beds and plantings; and around buildings. Controls weed in brick and gravel walks. Use for trimming and edging landscapes. Not recommended for spot weed treatment in lawns, since this product kills all green plants, including lawn grasses. If replacing a lawn or parts of a lawn, see for lawn renovation/replacement recommendations on this label. Spot treatments: direct spray on undesirable weeds and grasses in and around flower beds, ornamental trees, fruit and nut trees, grapevines, shrubs, fences, driveways and walkways. Spray when air is calm. Prevent this product's spray form contacting the leaves, green stems, or exposed roots of plants you like. Use a cardboard or plastic shield to protect desirable plants from spray or drift. This product will not move in or on the soil to untreated plants. If this product is used to control weeds around fruit or nut trees or grapevines, wait 21 days before eating the fruit or nuts. Landscapes: For use in preparing areas for planting of ornamentals, trees, shrubs, desert landscapes, rock gardens, flower beds or similar plantings. Treated areas can be planted one day after treatment. For lawn renovation/replacement: Use this product to kill existing vegetation (weeds and grasses and the old lawn). Apply in spring or fall, when daytime temperatures are at least 60 degrees F for best results. If the lawn is dry, water lawn every other day for seven days before applying this product. Do not mow for seven days before or after treatment. Use 2-1/2 fl oz per gallon of water for each 300 sq ft of area to treat. Wait seven days after application to prepare the soil by raking, leveling or rototilling. Rake up and remove loosened thatch or debris. Work in starter fertilizer and soil amendments, if needed. Level the soil. Sow new seed according to directions on seed package, or install sod. Grass seed must have good contact with soil to germinate and grow. Use temporary mulch such as straw to conserve moisture. Keep area moist for two weeks to establish new lawn. Water as needed. To control brush or vines: Apply to green and actively growing brush or vines. For plants taller than 5 ft, cut them back and spray the regrowth. Fall applications to brush may delay control to the following season. A second application may be required on hard-to-control species such as blackberry, kudzu, or poison oak. To kill vines growing up a pole, fence or mature tree trunk, cut vine to a height of 3 to 4 ft and spray thoroughly covering remaining vine. If vine is climbing a shrub or immature (green) tree trunk, to avoid damage to these plants, cut vine at base and treat as directed for stumps or spray regrowth. If spraying regrowth shield shrub and green trunk from drift with a sheet of plastic or cardboard. When to replant: All ornamental flowers, trees and shrubs and the following berries, fruits, vegetables and herbs may be planted one day after application. Artichoke (Jerusalem), beans (all), beet greens, blackberry, blueberry, boysenberry, broccoli, brussels sprouts, cabbage (all), carrot, cauliflower, celery, chard (Swiss), chicory, collards, cranberry, currant, dewberry, elderberry, endive, gooseberry, horseradish, huckleberry, kale, kohlrabi, leek, lentils, lettuce, loganberry, mustard greens, okra, olallieberry, onion, parsley, parsnips, potato, radish, rape greens, raspberry (black and red), rhubarb, rutabaga, spinach, sweet potato, turnip and yarns. The following fruits, vegetables and herbs may be planted three days after application: corn, cucumber, eggplant, garlic, gourds, melons (all), peas (all), peppers (all), pumpkin, squash (summer and winter), tomatillo, tomato (note: wait three days before planting tomatoes from seed and 30 days from rooted tomato transplants. For tomato transplants or vegetables not listed, wait 30 days after spraying before planting into treated soil) and watercress. Fruit and nut trees, caneberries and grapevines: allow 21 days before eating the fruits or nuts when using this product to control weeds around fruit or nut trees, caneberries and grapevines. Storage and Disposal: Pesticide storage: use and store this product only in its original container. Store product in a secure storage area away from source of heat or open flame. Protect product from freezing. Pesticide disposal: nonrefillable container. Do not reuse or refill this container. Offer for recycling if available. Call your local solid waste agency for disposable instructions. Never place unused product down any indoor or outdoor drain. Spill or leak: in case of spill or leak, soak up with paper towels and discard in trash.

Product Details

Makes up to 85 gallons. Contains 41% glyphosate. Kills weeds & grasses down to the root. Use in flower beds, along fences & around trees, shrubs, driveways & walkways. Covers up to 25,500 square feet. Water based. What it does: kills unwanted weeds & grasses. Where to use outdoors: driveways, walkways, curbs, patios; around fruits, trees, shrubs, flowers, vegetable gardens; along fences and sidewalks. This product will treat up to 25,500 square feet (approx. size of 12 tennis courts) for 1 gallon size. Ultra-Kill Weed & Grass Killer Concentrate eliminates nearly all common weeds, grasses and unwanted vegetation. Add water and use along fences, in driveways, sidewalks, brick and gravel walkways, next to trees and shrubs, and around buildings to control weeds and unwanted vegetation. Use this product for edging landscapes. This product is suited for lawn renovation or to prepare large sites for planting of flower beds or vegetable gardens. This product can also be used for large jobs such as lawn renovation and vegetable and flower garden preparation. Important: This product is a non-selective herbicide that will kill all vegetation contacted. This herbicide kills unwanted plants by inhibiting the production of a substance found only in plants. It enters plants through the sprayed foliage and moves down to the roots. Avoid direct spray or drift onto desirable plants, lawn grasses, shrubs and trees. Protect desirable plants and vegetation with a piece of plastic or cardboard. If desirable plants are accidentally sprayed, wash plants with water immediately. Any Ultra-Kill Weed & Grass Killer Concentrate not absorbed by the plant is broken down into natural materials. This product has no soil activity and thus will not affect nearly untreated plants. Do not mow, cut or otherwise disturb treated vegetation for at least seven days following application.

 

Ingredients

Active Ingredient: Glyphosate (N-[Phosphonomethyl] Glycine), in the Form of its Isopropylamine Salt (41%) (Acid Equivalent or Glyphosate Content = 30.34%). Other Ingredients (59%).

Warnings

Keep out of reach of children. Notice: Buyer assumes all responsibility for safety and use not in accordance with directions. Hazards to humans and domestic animals. Harmful if absorbed through the skin. Causes moderate eye irritation. Avoid contact with eyes, skin or clothing. Wash thoroughly with soap and water after handling. Keep children and pets away from treated areas until spray has dried. Avoid contamination of food. Do not contaminate water supplies. First Aid: If on Skin: Take off contaminated clothing. Rinse skin with plenty of water for 15-20 minutes. Call a Poison Control Center or doctor for treatment advice. If in Eyes: Hold eye open and rinse slowly and gently with water for 15-20 minutes. Remove contact lenses, if present, after the first 5 minutes, then continue rinsing eye. Call a Poison Control Center or doctor for treatment advice. Have the product container or label with you when calling a Poison Control Center or doctor, or going for treatment. You may also call 1-800-332-5553 for emergency medical treatment information. Environmental Hazards: To protect the environment, do not allow pesticide to enter or run off into storm drains, drainage ditches, gutters or surface waters. Applying this product in calm weather when rain is not predicted tor the next 24 hours will help to ensure that wind or rain does not blow or wash pesticide oft the treatment area. Rinsing application equipment over the treated area will help avoid runoff to water bodies or drainage systems.

Manufacturer

Chemsico/United Industries Corp.
PO Box 142642 St. Louis, MO 63114-0642 800-332-5553

Copyright 2008 UIC

UPC

044579412611