Titeseal Applicator Hose, Premium
16 oz (453 g)
On This Page
Directions
Before using, read entire label for important safety information. Directions: 1. if object that caused puncture is still in tire, do not remove. 2. For best results, rotate puncture to 6 o'clock position. 3. Shake can well before using. Warm can inside of car if weather is cold. Do not place can on hot surfaces, in warm water, or in direct sunlight which could cause can to burst violently. 4. Screw nozzle onto tire valve stem to seal and inflate tire. Some tires may require hubcap removal. 5. Inflate until can is empty. Rim should then be off ground. 10 to 15 pounds of pressure is adequate. Do not inflate to greater than manufacturer's maximum inflation pressure. 6. Unscrew connector from valve stem. Immediately drive slowly for 5 minutes to evenly spread sealant inside tire. During professional repair: Do not weld or attempt other rim repair without first removing tire from the rim. Never inflate tire with oxygen. Failure to follow instructions could result in violent explosion and and injury. Disposal: This is a single-use product. Use and dispose of container, product and residue in accordance with all local, state and federal laws and regulations. Storage: Store only in trunk or spare tire compartment, never store in interior of vehicle. Exposure to prolonged sunlight or heat source may cause can to burst. Do not expose to heat, sparks, open flame or store at temperatures above 120 degrees F. Do not puncture or incinerate container.
Product Details
Instant tire repair. Tire sensor safe. Seal & inflates in seconds. Premium applicator hose. Standard tire. Tire sensor safe formula. Contains no hydrocarbon gas. Non-flammable. Formulated for standard and mid-sized tires. Fast and convenient - no tools! No jacks! No mess! Seals most punctures up to 3/16 inches. Depending upon tire internal volume and aspect ratio, more than one can may be required for larger, higher volume tires. When used as directed Titeseal will get you to a service station for help. Sealant in this product is safe for use with original equipment tire pressure sensors. To ensure long term safety, inspection, tire repair, and internal cleaning of the tire and sensor are required. No CFCs: Contains no CFCs which deplete the ozone layer. www.TITE-SEAL.com. Made in USA.Nutrition Facts
Warnings
Caution: This product is a temporary repair only. Do not use on vehicles with less than four wheels. Deflation and loss of control can result in serious injury. Product will not seal faulty valves sidewall punctures, major tire damage, or if tire is separated from rim. Repair promptly. Have tire removed from rim, cleaned, inspected, and permanently repaired by a professional. Show repairman all cautions on this can. Before repairing puncture, completely release Titeseal gas in a well-ventilated area. Do not leave Titeseal inside tire as corrosion of wheels can result, and tire balance can be affected.,First Aid: Eye Contact: Flush thoroughly with water for 15 minutes while lifting eyelids and get prompt medical attention. Skin Contact: Wash with soap and water. If irritation develops, get prompt medical attention. Inhalation: Move to fresh air. If breathing becomes difficult, get prompt attention. Ingestion: Do not induce vomiting. Call Poison Control Center, physician or hospital emergency room immediately.,Warning: Eye irritant. Contents under pressure. Read precautions on back panel. Warning: Do not swallow. Use only as directed. Fire and explosion hazard. Breathing hazard. Contains: trans-1,3,3,3-tetrafluoroprop-1-ene (29118-24-9), water (7732-18-5), latex emulsion (9003-20-7), ethylene glycol (107-21-1), and ammonium hydroxide solution (1336-21-6), may irritate eyes and skin. Use only with adequate ventilation. Avoid prolonged breathing of vapor. Inhaling concentrated vapors, intentionally or otherwise, can cause death without warning. Keep away from children and animals.Manufacturer
Blumenthal Brands Integrated, LLC
Indian Trail, NC 28079-5225 U.S.A.
UPC
00078698131566