ACE Pipe, J Bend
1 set
On This Page
Directions
The J Bend is easy to install to your existing sink drain system. Installation Hint: Since it traps items that may fall into the drain and blocks gases from the waste drain system, water and dirt will be present in the existing trap. Place a bucket under the old trap before attempting to remove it. Tools Needed: Pipe or spud wrench (to remove old brass J Bend). Instructions: P or S type Trap: 1. Turn off water at the tap. 2. Remove old J Bend. 3. Remove inlet nut A from new J Bend and select 1-1/4 inch x 1-1/2 inch or 1-1/2 inch washer. 4. Place nut A and washer in tailpiece. 5. Put new J Bend into position. 6. Attach nut A and washer and nut B to J Bend as illustrated. Hand tighten. Run water to test for leaks. 1-1/2 inch IPS Sink Trap: Note: You may need to purchase a 1-1/2 inch iron pipe size threaded outlet elbow (Ace(hashtag)43787). 1. Turn off water at the tap. Remove old J Bend. 3. Remove out A from new J Bend and select 1-1/4 inch x 1-1/2 inch washer. 4. Place nut A and washer on tailpiece. 5. Remove and discard outlet nut and washer from J Bend. 6. Attach 1-1/2 inch Iron Pipe Size Threaded Elbow to J Bend and tighten nut B. 7. Position trap and hand tighten nut A to J Bend and C to threaded connection. Run water to test for leaks. Note: These parts are designed for a hand-tight installation. Pipe thread compound is not required.
Product Details
Quality since 1924. 1 1/2 in x 1 1/2 in or 1 1/2 in x 1 1/4 in. For P trap, S trap and IPS. For kitchen or bathroom. Compatible with brass plumbing. www.acehardware.com. Made in the USA. Manufactured in USA.Nutrition Facts
Manufacturer
ACE HARDWARE
Oak Brook, Illinois 60523 USA
UPC
00082901482727