Permatex Cold Weld, Steel Reinforced
1 set
On This Page
Directions
Directions: 1. For best results: Roughen, remove any grease and oil, clean and dry surfaces to be joined or repaired. 2. Remove tube caps. Pierce end of tubes with the back of cap. 3. Squeeze equal amounts of Resin and Hardener onto a discardable surface. Squeeze with equal pressure from bottom of tubes so diameter of bead is uniform. 4. Mix thoroughly until evenly colored. 5. Apply to surfaces to be joined or repaired. Epoxy starts to set in 8 minutes and reaches usable strength in 16 hours. When storing, clean caps and tube threads. Replace caps to original tube (color coded), or hardening may occur in tube nozzles.
Product Details
8 min. set time. 16 hour cure time. Up to 300 PSI strength. Dries dark grey. Bonds to: Aluminum, brass, bronze, copper, iron, stainless steel, & steel. One hardener / One resin. Permatex Cold Weld is a two-part, high strength, cold welding epoxy that can be drilled threaded, machined, filed or painted once fully cured. Has a test-proven shear strength greater than 3,000 PSI after 16 hours. Resistant to shop fluids, including diesel fuel, gasoline, antifreeze, water, oil, transmission fluids, and hydraulic fluids. Temperature Range: -60 degrees F to 300 degrees F continuous, -60 degrees F to 350 degrees F intermittent. www.permatex.com. Toll Free: 866-732-9502. Assembled in USA with US and global materials.Nutrition Facts
Warnings
Warning: Cancer - www.P65Warnings.ca.gov.,Precautionary Statements - Prevention: Contains: Limestone, Bis[4-(2,3-Epoxypropoxy)- phenyl]propane, Iron, Amorphous silica, Silicon, Benzyl alcohol, Crystalline silica. 2,4,6,-tris- (dimethylaminomethyl)phenol. Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Use personal protective equipment as required. Wash face, hands, and any exposed skin thoroughly after handling. Avoid breathing dust/fume/gas/mist/ vapors/spray. Contaminated work clothing should not be allowed out of the workplace. Wear protective gloves/protective clothing/eye protection/face protection. Precautionary Statements - Response: If in Eyes: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: Get medical advice/attention. If on Skin: Wash with plenty of soap and water. If skin irritation or rash occurs. Get medical advice/attention. Wash contaminated clothing before reuse. Precautionary Statements - Storage: Store in a well-ventilated place. Keep container tightly closed. Precautionary Statements - Disposal: Dispose of contents/container to an approved waste disposal plant. Keep out of the reach of children.,Warning: Causes skin irritation and serious eye irritation. May cause allergic skin reaction. May cause cancer.Manufacturer
Illinois Tool Works Inc.
Solon, OH 44139
UPC
00686226146007