Permatex Gasket Maker, High Temp, Ultra Red
13 oz (368 g)
On This Page
Directions
Directions: 1. For best results, surfaces should be clean and dry. Cut off tip of cartridge. 2. Attach nozzle, cut at 45 degree angle at desired point and insert cartridge into a caulking gun. 3. apply a a continuous 1/16 in a 1/4 in (2 to 6 mm) bead of silicone to one surface, surrounding all bolt holes. Assemble parts immediately while silicone is still wet. Finger tighten until material begins to squeeze out around flange. 4. Let dry for one hour then tighten to torque specification. Allow 24 hours to fully cure before filling with fluids or returning to service. 5. To reuse package, leave 1/2 in length of material extended from nozzle; cured material will form a protective plug. To reuse, carefully remove the plug and dispense as before. Note: Not recommended for use on head gaskets or parts in contact with gasoline.
Product Details
High temperature applications. -65 degrees F to 650 degrees F (-54 degrees C to 343 degrees C) intermittent. Sensor safe. RTV silicone. Ultra Red Gasket Maker retains a high temperature resistance while remaining resistant to oils and common shop fluids. Meets OEM specs. www.permatex.com. Assembled in U.S.A. with U.S. and global materials.Nutrition Facts
Warnings
Precautionary Statements Prevention: Contains: calcium carbonate, iron oxide. Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Use personal protective equipment as required. Wash face, hands and any exposed skin thoroughly after handling. Avoid breathing dust/fume/gas/mist/vapors/spray. Contaminated work clothing should not be allowed out of the workplace. Wear protective gloves/protective clothing/eye protection/face protection. Precautionary Statements - Response: If in Eyes: Rinse cautiously with water for several minutes. Remove contact lenses. if present and easy to do. Continue rinsing. If eye irritation persists: Get medical advice/attention. If on Skin: Wash with plenty of soap and water, If skin irritation occurs: Get medical advice/attention. Wash contaminated clothing before reuse. Precautionary Statements - Storage: Store locked up. Precautionary Statements - Disposal: Dispose of contents/container to an approved waste disposal plant.,Warning: On direct contact, uncured sealant irritates eyes and skin. Read carefully other cautions on back panel. Keep out of the reach of children.Manufacturer
Illinois Tool Works Inc.
Solon, OH 44139
UPC
00686226816245