ACE S Trap 1 ea BAG
On This Page
Directions
The S Trap is easy to install as a waste connection between a sink tailpiece and floor outlet. Installation Hints: Since it traps items that may fall into the drain and blocks gases from the waste drain system, water and dirt will be present in the existing trap. Place a bucket under the old trap before attempting to remove it. Put thread seal tape on the drain threads before attaching nuts. This will provide a better seal against leaks. Use a scrap of cloth to protect chrome finish on the nuts when you tighten with a pipe wrench. Tools Needed: Pipe or spud wrench; thread seal tape. Instructions: 1. Turn off water at the tap. 2. Remove old S Trap. 3. Remove nuts A and D and washers B and C from inlet and outlet of J Bend. 4. Slip nut D along entire length of drain tube as illustrated. 5. Slide flange over drain tube. 6. Attach drain tube to waste line at floor. Note: For new installations, be sure you have the proper adapter in drain line to accept the drain tube. 7. Put washer C from outlet of J Bend on drain tube. 8. Put nut A and washer B to tailpiece. 9. Position J Bend. Hand-tighten nuts from tailpiece and drain tube. 10. Align parts and tighten with wrench. Run water to test for leaks. 11. Slide flange to the wall.
Description
1-1/2 in x 1-1/2 in or 1-1/2 in x 1-1/4 in. Quality since 1924. For floor connection in kitchen or bathroom. Compatible with brass plumbing.Warnings
Not ApplicableUPC
00082901482741