Flex Shot Sealant, Thick Rubber Adhesive, Black
8 oz (226 g)
On This Page
Directions
Directions For Use: 1. All surfaces must be clean, dry and free from dirt, grease and oil. 2. Hold can at 45 degrees angle, push against the nozzle side and apply into the joint or seam to obtain full contact between surfaces. 3. Flex shot can be smoothed within 5 minutes of application. Remove excess immediately with a dry paper towel. 4. Sealant forms a tack free skin in 20 minutes. Length of full cure depends upon factors such as temperature and humidity, but sections up to 1/8 inches become rubbery solids in about 24 hours. 5. After using, extend a small amount of material beyond the end of the nozzle. this will cure and form a seal for the remaining material. Pull out this cured plug when you are ready to use again. Storage: Protect from sunlight store in a wall-ventilated place.
Product Details
As seen on TV. The easy way to caulk, bond & seal. Easy to use. Leak proof seal. Strong bond. Excellent for: kitchens & baths sinks & showers tubs & tiles windows & skylights roofs & gutters autos & boats RV's & campers PVC pipes Duct work anywhere you need a tight, leak proof seal & strong bond! Perfect bead every time. Flex shot is a thick, rubberized paste that fills cracks and holes. It dries to a tough, flexible, watertight seal. Flex shot seals out water, air and moisture. Flex shot comes with an easy to use nozzle that gives you a perfect bead every time. No need for a caulking gun! Flex shot is the easy way to caulk, bond & seal virtually everything! Jumbo can. Phil swift. www.flexshot.com. Customer service: 877-370-0632, to order more flex shot:877-857-5795. www.flexshot.com. No CFCs. Contains no CFCs which deplete the ozone layer. Made in USA.Nutrition Facts
Warnings
Caution: Causes skin irritation. Contents under pressure. Contains flammable propellant. Read rear panel for other cautions! Keep out of the reach of children. Warning: Uncured sealant causes irritation on contact with skin and eyes. In Case of contact with skin, wipe off with paper towels or cloth and wash with soap And water. in case of eye contact, immediately flush with water for 15 minutes. call a physician immediately. Use with adequate ventilation. Contents under pressure. Do not puncture or incinerate. Do not remove rubber plug. Do not store at temperatures above 120 degrees F. Do not store in automobiles, in direct sunlight or any area with temperatures above 120 degrees F. Keep container away from heat, sparks and flame. See Material Safety Data Sheet. Contains: Dimethylsiloxane (CAS no 70131-67-8), Silica (CAS no 7631-86-9), Methyltriacetoxysilane (CAS no 4253-34-3), Ethyltrimethoxysilane (CAS no 17689-77-9), Petroleum distillates (CAS no 64742-46-7), Difluoroethane (CAS no 75-37-6), Polydimethylsiloxane (CAS no 63148-62-9) and Carbon black (CAS no 1333-86-4). Warning: contains gas under pressure: may explode if heated. Causes serious eve and skin irritation. Prevention: wear protective gloves. Wear eye or face protection. Wash hands thoroughly after handling. Response: if on skin: wash with plenty of soap and water. Take off contaminated clothing. Wash contaminated doting before reuse. If skin irritation occurs: get medical attention. If in eyes. Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: get medical attention.Manufacturer
Swift Response
Weston, FL 33331
UPC
00855647003378