B'laster R-134a Recharge Kit
18 oz (510 g)
On This Page
Directions
Refer to the A/C nameplate under the hood or owner's manual to determine the correct refrigerant and correct charge for the vehicle. Check hoses and ports for leaks and repair before recharging. Instructions: 1. Open vehicle hood, locate the low-side service port and remove port cap. Recharge hose will only connect to the low-side port. 2. Start the engine and turn on A/C. Set controls to maximum cool, maximum air flow and recirculation mode. Close all windows and doors of vehicle. 3. Shake the can well and connect recharge hose to low-side service port. Tighten recharge hose to can by turning clockwise. Pull the quick connect coupler ring back as you push fitting onto the port. Ensure coupler locks in place to prevent leaking. 4. Determine the ideal psi level using temperature pressure chart and check system pressure. Some vehicles with expansion valves cannot be accurately charged using low-side pressure gauge only. If your gauge is not increasing, stop charging and check air vent temperature. The PSI may only increase to 25-30 psi on these systems. Ambient Temperature: 65 degrees F (18 degrees C); Low-Pressure Gauge (PSI): 25-35 psi / 172-241kPa. Ambient Temperature: 70 degrees F (21 degrees C); Low-Pressure Gauge (PSI): 35-40 psi / 241-276kPa. Ambient Temperature: 75 degrees F (24 degrees C); Low-Pressure Gauge (PSI): 35-45 psi / 241-310kPa. Ambient Temperature: 80 degrees F (27 degrees C); Low-Pressure Gauge (PSI): 40-50 psi / 276-345kPa. Ambient Temperature: 85 degrees F (29 degrees C); Low-Pressure Gauge (PSI): 45-55 psi / 310-379kPa. Ambient Temperature: 90 degrees F (32 degrees C); Low-Pressure Gauge (PSI): 45-55 psi / 310-379kPa. Ambient Temperature: 95 degrees F+ (35 degrees C+); Low-Pressure Gauge (PSI): 50-55 psi / 345-379kPa. Read gauge pressure when the compressor clutch cycles on. If the gauge reads: Below 25 PSI: system is low on refrigerant. Begin recharging process. 25-55 PSI: system may be properly charged. Above 55 PSI: If compressor clutch is cycled on, do not recharge - seek a mechanic's assistance. 5. Add refrigerant to the system. Turn push-button on top of can to the unlock position. Push button down while continually rotating the can in a sweeping motion from the 12 o'clock to 3 o'clock position. 6. Check gauge pressure every 10-15 seconds by releasing the push button. Continue process until the gauge reaches the ideal PSI level according to the chart. If your gauge is not increasing, stop charging and check A/C vent temperature. Do not overcharge. Do not vent. 7. Stop charging when correct PSI level is reached and A/C is blowing cold. Remove the charging hose from the service port and store can in a cool, dry place or discard according to state or local guidelines. Bonus: Recharge hose can be detached and reused. Not for use on hybrid/electric vehicles with non-belt driven (electric driven) compressor.
Product Details
New. Recovery machine safe. Work it like a pro. Since 1957. Safe-seal with UV dye. Stops leaks in metal & rubber components. Restores maximum cold air. Conditions seals to prevent future leaks. Reusable recharge hose with pressure gauge. B'laster R-134a Recharge Kit: Contains 18 oz. of R-134a with Safe-Seal to seal common leaks in both metal and rubber a/c components. UV dye glows under UV light to reveal larger leaks that may need repair. blasterproducts.com. For more info visit blasterproducts.com. Made in USA from US and imported parts.Nutrition Facts
Warnings
Warning: This Product can expose you to chemicals including lead, cadmium, and DBP which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.,Warning: Contents under pressure. Read cautions on back. Caution: Always wear protective rubber gloves and eye wear. Danger: Never place refrigerant can on any hot engine part. Danger: Store in cool place - never in passenger cabin of vehicle as can may explode. Do not expose to temperatures above 120 degrees F. Do not puncture or incinerate. Contents of this container contribute to global warming. Warning: Keep out of reach of children. Exposure to skin may cause frostbite flush with warm water. If sprayed into eyes, flush with warm water. If inhaled, remove to fresh air and call physician immediately. Contains 1,1,1,2 tetrafluoroethane (cas # 811-97-2). Safety Data Sheets available online.Manufacturer
B'laster LLC
Cleveland, OH 44125
UPC
00850024094826