Black + Decker Edger Blade, Heavy Duty, 7-1/2 Inch
1 blade
On This Page
Directions
Instructions for Edger Blade Replacement: To remove the blade and attach new blade (see Figure 1): 1. Wait for the blade to come to a complete stop and unplug tool. 2. Use 1 in. wrench on outer washer to hold the blade from turning. Loosen hex nut. 3. Replace blade and washers with new supplied blade and washers. 4. Place washer on shaft- flats in washer hole must engage with flats on shaft. 5. Place blade on shaft. 6. Place second washer on shaft over blade, align flats in washer with flats on shaft. 7. Install hex nut and tighten securely (about 1/2 turn, 140 in.-lbs.)
Product Details
Fits: LE750. EH1000. Serrated Edges for aggressive cut. Hardened steel for long life. This blade has wear indicators (Fig. 2). When blade wears to the small hole at each end of the blade it will give approx. 3/8 in (9.5 mm) depth of cut and should be replaced. BlackandDecker.com. Made in China.Nutrition Facts
Warnings
Safety instructions. Always wear ANSI Z87.1 eye protection and protective clothing. Check edger for any damage and replace if necessary. Do not sharpen blade in any way. Make sure edging area 100 ft (30 m) is clear prior to starting operation. Use of this accessory on anything other than the intended product could be hazardous. Read edger instruction manual for additional safety instructions prior to use!Manufacturer
BLACK & DECKER
701 East Joppa Road Towson, MD 21286 USA
UPC
00028877306308