1. Home
  2. Sockets/Receptacles/Outlets
  3. Stanley TimeIt Outdoor Twin 2 Outlet 24hr Mechanical Timer

Stanley TimeIt Outdoor Twin 2 Outlet 24hr Mechanical Timer

On This Page

 

Directions

Instructions: 1. Locate an electrical outlet that is close to the device you want to control. 2. Put the "on/timer" switch located adjacent to the dial to the "timer" position and plug the timer into the outlet. 3. Set the current time - turning clockwise, align the arrowhead (See diagram) on the dial of the timer to the present time (lines above the numbers are in increments of 30 minutes). There is no need to touch the pins to set the current time. Note: dial is based on AM/PM. 4. Determine your desired start time and push down all pins until desired OFF time. The timer pins are factory preset in the "pushed down" or "ON" position. Pull up all of the pins before pushing down pins for your desired "on" time. Note: The "pins" are grey slices around the dial. For example: to turn the timer on at 5pm and off at 10pm, push down all the pins between 5PM and 10PM. 5. Plug your electrical device directly into the timer. The electrical device must be set to "ON" position for the timer control to work properly. 6. The "on/timer" switch on the timer must be set to the timer position for the timer function to work. You may override operation of the timer by setting the "ON/TIMER" switch (located adjacent to the dial) to ON (top position). Be sure to set switch back to the timer (bottom position) for proper timer function. In case of power failure, reset the time of day as indicated in steps 3 above. Limitations of timing devices: Timing devices require power to function properly. If AC power to the timer is cut off, a light or other device plugged into the timer will not work. Notes: 1. The unit you are plugging into the timer has to be on. 2. Make sure AM and PM are correct on the current time and in the program settings. Timer pins are factory preset in the "pushed down" ('ON') position. Pull pins up for timers 'OFF' intervals.

 

Description

Stanley® Timelt® Outdoor Twin 2-Outlet 24hr Mechanical Timer. Two grounded outlets. Program repeats daily. Multiple on/off settings possible in a 24-hour period. Slide-pin construction prevents lost pins. Grounded outlets. E-Z setup. Daily. 2 built-in ground outlets. Outdoor. Quality products for a safe holiday.

Other Description

Timelt outdoor twin: Two grounded outlets. Program repeats daily. Multiple on/off settings possible in a 24-hour period. Slide-pin construction prevents lost pins. Not recommended for CFL bulbs. 6in. AWG 14/3 SJTW vinyl cord. Rated: 125VAC/60Hz/8A/1000W resistive (appliance). 8A/1000W tungsten (Incandescent). 500VA electronic ballast. 1/2HP motor load. Customer service assistance: toll free 1-800-730-3707 hours of operation: 10AM-6PM, EST, Monday - Friday. See cautions, warnings and instructions on inside of package. Timelt® outdoor twin. 2-outlet 24hr mechanical timer. 2-Outlet 24hr mechanical timer. 2 grounded outlets and plug. Can be set in 30 minute intervals. Program repeats daily. Slide pin construction prevents lost pins. Manual override switch. Perfect for controlling holiday decorations & Christmas lighting. Convenient, easy to use and energy saving. Specifications: 125VAC/60Hz/8A/1000W Resistive. 8A/1000W Tungsten (Incandescent). 500VA Electronic ballast. 1/2HP Motor load. 6in AWG 18/3 SJTW vinyl cord. Save these instructions! Stanley and the Stanley logo are registered trademarks of Stanley Black & Decker, Inc., or one of its affiliates, and are used under license. 3 Year limited guarantee. Customer Service Assistance: Toll Free 1-800-730-3707 hours of operation: 10AM to 6PM, EST, Monday - Friday. www.thencc.com. ©2014 The NCC.

Warnings

Prop 65 warning: the power cord of this product contains lead, a chemical known to the State of California to cause cancer, and birth defects or other reproductive harm. Wash hands after handling.
When used outdoors this timer must be plugged into a GFCI protected outlet to provent shock hazard. Let the switch hang downward so moisture doesn't accumulate in the outlet. Install cord and unit above ground level with the receptacle pointed downward a minimum of 5ft (1.5m) above ground. Suitable for damp locations. Not for water immersion or for use where directly exposed to water. Store indoors when not in use.
Caution:
Do not plug this timer into an extension cord or other electrical adapter. Plug directly into an electrical outlet.
Do not connect this timer to appliances that contain heating elements (cooking appliances, heaters, irons, etc.) Failure of the timer to shut off such devices may lead to overheating and a potential fire.
Do not plug in this timer if it is wet.
Do not clean this timer when it is plugged in.
Do not exceed the maximum ratings of the timer.
Potential shock hazard: Keep out of reach of children.

Distributor

The NCC
Brooklyn, NY 11220
1-800-730-3707
www.thencc.com

UPC

00686140564338