Command Picture Hangers, Universal
1 set
On This Page
Directions
Apply: 1. Clean wall with rubbing alcohol. Do not use household cleaners. 2. For wire back frames, position post at the bottom. For sawtooth and other frames, position post at the top. Remove red liner and press adhesive to hanger. 3. Remove black liner. Press hanger firmly to wall for 30 sec. Wait 1 hour before hanging frame. 4. When ready to hang the frame, separate the stabilizer strips. Press two strips together until they click. 5. Remove one side of linersl. Place each pair of strips as shown. Press firmly. 6. Hang picture on hanger. Remove remaining liners and press frame to wall for 30 secs. Remove: 1. Grab bottom corners and peel frame from wall. Do not pull straight off. 2. Hold hanger gently in place. Never pull the strip towards you! Always pull straight down. 3. Stretch each strip slowly against the wall at least 15 inches. Repeat for stabilizer strips.
Product Details
Holds 5 lb (2.2 kg). Up to 11 in x 17 in (28 cm x 43 cm). Damage-free hanging. Holds strongly. Removes cleanly. Hanger can be reused with Command Large Refill Strips. Limited Warranty and Limitation of Liability [For product sold in USA]: This product will be free from manufacturing defects. If defective, your exclusive remedy shall be, at 3M's option, product replacement or refund. 3M will not be liable for any loss or damage arising from this product, whether direct. Indirect, special, incidental or consequential. command.com. Hangers made in China. Strips made in USA.Nutrition Facts
Warnings
Do not hang over beds or on wallpaper. Do not hang valuable or irreplaceable items. Use one hanger per picture. Use indoors 50 degrees - 105 degrees F.,Wait 7 days after painting before use. Failure to follow instructions carefully may cause damage. Save instructions or visit command.com.Manufacturer
3M
3M Center St. Paul, MN 55144
UPC
00051141370040