Dundas Jafine Pro Clean Duct Brush, Drill Powered
1 brush
On This Page
Product Details
Extends up to 8 inches (2.4 m). Removes lint build up and debris. For use with or without a drill. For use in dryer and other general duct cleaning. Contents: Four 2 inches flexible rods. One 4 inches diameter brush hood. To clean dryer duct from inside or outside: 1 Unplug dryer and remove dryer duct. 2 Remove or open exterior vent hood. 3 Connect the brush so any of the rod (1) and secure each connection with duct tape for added reinforcement. 4 Insert brush/rod assembly into wall through duct opening where dryer was connected or through outside vent hood opening. Note: A drill can be attached to the brush/rod assembly for more effective cleaning. Caution: Rotate brush/rod assembly only in a clockwise direction. Reversing the direction could cause the brush hood or rod(s) to detach inside the duct. 5 While turning in a clockwise direction, gently push and pull brush/rod assembly 12 inches of a time. Repeat until entire length of duct is clean. Caution: Never force the brush/rod assembly through the duct. If it should become jammed, pull assembly away from constricted area a few inches (still rotating in a clockwise direction) then slowly push forward. 6 Check outside vent hood and inside wall duct opening to ensure entire duct has been cleaned, remove any lint pushed out from the cleaning process and close or replace hood. 7 Reconnect the dryer duct to the dryer and push dryer bock into place. 8 Turn on dryer and ensure the air is flowing properly throughout the duct and exhausting air through the outside vent cap. Recommended products to improve your installation. Excess dryer vent hood. Semi-rigid aluminium duct. Dryer lint clean out connector. Innovators in dryer safety solutions. www.dundasjafine.com. Made in China.Nutrition Facts
Manufacturer
Dundas Jafine
Adden, New York 14001 USA
UPC
00060672150021