HTH 3 Shock 'n Swim
On This Page
Directions
Why you should use this product: This product is convenient, easy to use, and won't over-stabilize your pool. For crystal clean pool water, the makers of Hth® recommend the following 4 step pool care program: Step 1: test and balance water. Step 2: sanitize. Step 3: shock at least once a week, and step 4: add algaecide as directed. Additional shocking to keep water clean and clear is recommended after: rain and heavy winds; high number of swimmers; increased water temperature; and/or increased frequency of pool usage. Directions for use: It is a violation of federal law to use this product in a manner inconsistent with its labeling. Read all precautionary statements before use. How to use: do not pre-mix this product before adding it to your pool. Only add this product directly to your pool or skimmer. Use entire contents when opened. Method for dosing directly into pool: add the recommended dosage of this product during evening hours while the filter pump is running. When adding this product to your pool, broadcast the product evenly over a wide area in the deepest part of the pool. If any granules settle to the bottom of the pool, use brush to disperse. Method for skimmer addition: make sure that filter pump is on and properly recirculating through skimmer. Empty skimmer of all chemicals and/or debris. Contamination may cause an explosion or the release of toxic gases. Do not use this method when an automatic chemical dispensing device (e.g. feeder) is present. Pour this product slowly into skimmer, making sure that the material is drawn into the system at the same rate: do not allow this material to accumulate as toxic gases may be generated. Water balance: for best product performance, swimmer comfort and crystal clear water, use Hth pool care products to maintain the following water balance. Acceptable range for balance. PH: 7.2-7.6. Total alkalinity 60-120 ppm. Calcium hardness: above 200 ppm. Available chlorine: 1-4 ppm. Follow label directions for each product and allow each product to dissolve and disperse before adding additional products to the pool. Use a reliable test kit that measures all these ranges. Re-entry into treated pools is prohibited above levels of 4 ppm for risk of bodily injury. Opening your pool: for best results, see the "water balance" section above before treatment. Adjust and maintain ph in the 7.2 to 7.6 range. Allow the ph adjusters to dissolve and disperse before adding this product to the pool. 1. Follow "pool shock treatment" directions on this package. 2. Allow 30 minutes for product to disperse. 3. Test free available chlorine residual with a pool test kit. 4. Repeat dosage, as needed, until the free available chlorine residual is 1-4 ppm. Re-entry into treated pools is prohibited above levels of 4 ppm for risk of bodily injury. As a preventative treatment, you should shock treat your pool once a week to prevent pool problems. In addition to weekly shock treatment, you should shock treat to remedy problems which occur when bather loads are high, water appears hazy or dull, unpleasant odors or eye irritation occur, after heavy wind and rainstorms, or if algae does develop with resulting green color and slimy feeling walls. Pool shock treatment: add the recommended dosages of this product while the filter pump is running. Adjust and maintain pH to 7.2 to 7.6 with Hth pH Plus® or Hth pH minus. Follow label directions. When adding this product to your pool, broadcast this product evenly over a wide area of the deepest part of the pool. Dosage rate: shock treatment / super. Chlorination: for best results, see "water balance" and how to use" section above before treatment. Every 7 days, or as necessary to prevent pool problems, shock treat/super chlorinate the pool by adding 16 to 32 ounces (one to two bags) per 11,500 gallons of water to yield 5 to 10 ppm available chlorine by weight. Re-entry into treated pools is prohibited above levels of 4ppm for risk of bodily injury. Algae control: 1. Follow "pool shock treatment" directions on this label. 2. Add this product as close as possible to any algae on the sides or bottom of the pool. 3. Do not enter pool until the free available chlorine residual is 1-4 ppm. 4. If necessary, repeat the treatment. 5. To prevent possible staining or bleaching, take the following steps immediately after treatment: thoroughly clean pool by brushing surface of algae growth, vacuum and cycle through filter. For preventative algae control, use your preferred Hth algaecide product regularly.
Description
HTH™ Shock 'n swim. Destroys organic contaminants. 1 balance. 2 sanitize. 3 shock. 4 prevent algae.Other Description
Hth® and pH Plus® are registered trademarks of Arch Chemicals, Inc. The Hth™ logo is a trademark of Arch Chemicals, Inc. Helpline: 866-HTH-POOL. Toll-free. Call 7 days a week with your questions concerning pool water care. 8:00 A.M.-10:00 P.M. eastern time. Visit Hth Pools www.hthpools.com. In case of emergency call: 1-800-654-6911.Ingredients
Active Ingredient: Calcium Hypochlorite - 47.6%. Other Ingredients - 52.4%. Total - 100.0%. Minimum Available Chlorine - 45%.Warnings
Keep out of reach of children.Danger:
Contamination or improper use may cause fire, explosion or the release of toxic gases. Do not allow product to contact any foreign matter, including other water treatment products. If product is exposed to small amounts of water, it can react violently to produce heat and toxic gases and spatter. Do not add water to this product. Add only into water. Do not mix this product with a small amount of water. Only add directly to your pool. Corrosive. Causes irreversible eye damage and skin bums. Harmful if swallowed, inhaled, or absorbed through the skin.
Read all precautionary statements on label and all first aid statements before use.
First aid:
If in eyes:
Hold eye open and rinse slowly and gently with water for 15-20 minutes. Remove contact lenses, if present, after the first 5 minutes, then continue rinsing eye. Call a Poison Control Center or doctor for treatment advice.
If on skin or clothing:
Take off contaminated clothing. Rinse skin immediately with plenty of water for 15-20 minutes. Call a Poison Control Center or doctor for treatment advice.
If swallowed:
Call a Poison Control Center or doctor immediately for treatment advice. Have person sip a glass of water if able to swallow. Do not induce vomiting unless told to do so by a poison control center or doctor. Do not give anything by mouth to an unconscious person.
If inhaled: remove person to fresh air. If person is not breathing, call 911 or an ambulance, then give artificial respiration, preferably mouth-to-mouth if possible. Call a poison control center or doctor for further treatment advice.
Note to physician:
Probable mucosal damage may contraindicate the use of gastric lavage. Have the product container or label with you when calling a poison control center or doctor, or going for treatment.
In case of emergency call: 1-800-654-6911.
Precautionary statements: hazards to humans and domestic animals: danger. Corrosive. Causes irreversible eye damage or skin burns. Harmful if swallowed, or absorbed through skin.
Open in a well ventilated area. Avoid breathing dust and fumes.
Do not get in eyes, on skin or on clothing. Wear goggles and rubber gloves. For additional protection of skin, wear long sleeves and long pants.
Wash hands after handling and before eating, drinking, chewing gum, using tobacco or using the toilet.
Remove contaminated clothing and wash clothing before reuse.
Physical and chemical hazards: danger. If product is exposed to small amounts of water, it can react violently to produce heat and toxic gas and spatter. Do not add water to this product. Add only into water.
Do not mix this product with a small amount of water. Only add this product directly to your pool.
Do not allow to become wet or damp before use.
Can react with other materials, including other water treatment products, to cause fire, explosion, and the release of toxic gases.
Keep all foreign matter, including other water treatment products, away from this product.
Use only clean dry utensils to dispense this product.
Do not allow this product to contact other water treatment products. If used with a skimmer, make sure skimmer is completely clean and free of residue from other water treatment products before putting this product in a skimmer.
Avoid spilling this product.
Exposure to heat can cause this product to rapidly decompose, leading to fire, explosion, and the release of toxic gases.
Store in a cool, dry, well ventilated area away from heat or open flame. Strong oxidizing agent. This product can increase fire intensity.
Keep away from heat and from flame and burning material (like a lighted cigarette).
Environmental hazard: this pesticide is toxic to fish and aquatic organisms.
Storage & disposal:
Keep this product dry in its tightly closed container. Store in a cool, dry, well-ventilated area. Keep away from heat or open flame.
Nonrefillable container. Do not reuse or refill this container. Rinse and discard empty container thoroughly with water to dissolve all material prior to disposal. Offer for recycling if available. Do not contaminate food or feed by storage or disposal or cleaning of equipment.
For disposal of a contaminated or decomposing product see "emergency handling".
Emergency handling:
In case of contamination or decomposition-do not reseal container. Immediately remove container to an open and well-ventilated outdoor area by itself. Flood with large amounts of water until the material is dissolved. Dispose of container and any remaining material in an approved landfill area.
Stop!
Do not mix with other products or dissolve before use.
Read precautions/first aid statements on label.
UPC
00073187511034