Command Damage-Free Hanging Satin Nickel Hand Towel Bar
On This Page
Directions
Apply: 1. If possible, choose a spot where strips are not over grout lines. 2. Clean surface with rubbing alcohol. Do not use household cleaners. 3. Separate strips. Remove blue liners. Press 2 strips to each mounting base. 4. Remove black liners. Press towel bar to wall for 10 seconds. 5. To ensure adhesive hold, slide towel bar up and off. 6. Press each base firmly for 30 seconds. 7. Wait 24 hours to allow adhesive to build. Then slide towel bar back into the mounting bases. Remove: 1. Slide towel bar up and off. 2. Gently hold mounting base in place. 3. Never pull the strip towards you! Always pull straight down. 4. Stretch each strip slowly against the wall at least 12 inches to release.
Description
3M Command™ Damage-Free Hanging Satin Nickel Hand Towel Bar. Brand. New! Holds strongly. Removes cleanly. Proven to hold better than suction cups. Rust resistant. Holds 3lb. 1, 3kg.Other Description
Water resistant strips. Limited warranty and limitation of liability (for product sold in USA). This product will be free from manufacturing defects. If defective, your exclusive remedy shall be, at 3M's option, product replacement or refund. 3M will not be liable for any loss or damage arising from this product, whether direct, indirect, special, incidental or consequential. All rights reserved. 3M and Command are trademarks of 3M. Save instructions or visit www.command.com. © 2015, 3M.Warnings
Failure to follow instructions carefully may cause damage.Caution: Do not hang over beds or on wallpaper. Do not hang valuable or irreplaceable items or framed pictures. Apply and use 15°-125°F.
Distributor
3M Center, St. Paul, MN 551441-800-934-7355
www.command.com
UPC
00076308731892