Command Damage-Free Hanging Outdoor Light Clips - 16 CT
On This Page
Directions
Apply: 1. Apply to a smooth, clean and dry surface. Clean with rubbing alcohol. Do not use household cleaners. 2. Separate strips. Remove blue liner. Press adhesive to clip. 3. Remove black liner. Press firmly to surface for 30 seconds per clip. 4. Use one clip for every 2 feel to lights. 5. Wait 1 hour before hanging lights. Remove: 1. Gently hold clip in place. 2. Never pull the strip towards you! Always pull straight down. 3. Stretch the strip slowly against the wall at least 6 inches to release.
Description
Command™ Damage-Free Hanging Outdoor Light Clips. Holds Strongly. Removes Cleanly. Outdoor Exteriores.Other Description
Clips can be reused with Command® Outdoor Small Refill Strips. Limited Warranty and Limitation of Liability [for product sold in USA]: This product will be free from manufacturing defects. If defective, your exclusive remedy shall be, at 3M's option, product replacement or refund. 3M will not be liable for any loss or damage arising from this product, whether direct, indirect, special, incidental or consequential. 3M and Command are trademarks of 3M. All rights reserved. 1-800-934-7355. www.command.com. © 2015, 3M.Warnings
Caution:Do not hang over beds or on wallpaper. Do not hang valuable or irreplaceable items or framed pictures. Apply 15° to 125°F. Holds -20° to 125°F.
• Not Recommended on rough surfaces, such as cement board, brick or rough-sawn wood.
• Failure to follow instructions carefully may cause damage.
Distributor
3M Center, St. Paul, MN 55144UPC
00051141372914