Hamilton Beach Iron 1 ea NOT PACKED
On This Page
Directions
How to Dry Iron: 1. Set steam switch to 2. Turn temperature control dial to desired temperature. Allow 2 minutes to reach desired temperature. How to Steam Iron: 1. Unplug iron. Then, using a measuring cup with a small pour spout, pour tap water into water fill opening and fill iron to max fill line. If you have extremely hard water, alternate between tap water and distilled water for use in the iron. Plug iron into outlet. 2. Turn temperature control dial to select desired fabric setting in the steam range. Allow 2 minutes for the iron to reach the desired temperature. Caution Burn Hazard: Attempting to steam iron on a lower temperature setting or failing to allow the iron to preheat for 2 minutes can result in hot water dripping from the soleplate. 3. Set adjustable steam switch to desired steam setting. Read before use. Important Safety Instructions: When using electrical appliances, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and/or injury to persons, including the following: 1. Read all instructions. 2. This appliance is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge, unless they are closely supervised and instructed concerning use of the appliance by a person responsible for their safety. 3. Close supervision is necessary when any appliance is used by or near children. Children should be supervised to ensure that they do not play with the appliance. 4. Only use an iron for its intended use. 5. To avoid the risk of electric shock, do not immerse the iron in water or other liquids. 6. Always turn the iron to off before plugging or unplugging the iron from the electrical outlet. Never pull on the cord to disconnect the iron from the electrical outlet; instead, grasp the plug and pull on the plug to disconnect the iron. 7. Do not let the cord touch hot surfaces. Let the iron cool completely before putting the iron away. Loop cord loosely around iron for storing. 8. Always disconnect the iron from the electrical outlet before filling the iron with water, emptying the water from the iron, and when the iron is not in use. 9. Do not operate the iron with a damaged cord or in the event the iron has been dropped or damaged or there are visible signs of damage or it is leaking. To avoid the risk of electric shock, do not disassemble the iron. Take it to a qualified serviceman for examination and repair. Incorrect assembly might result in a risk of electric shock when the iron is used after reassembly. 10. The iron must be used and rested on a stable surface. 11. When placing the iron on its stand, ensure that the surface on which the stand is placed is stable. 12. Do not leave the iron unattended while the iron is connected or on an ironing board. 13. Bums can occur from touching hot metal parts, hot water, or steam. Use caution when you turn a steam iron upside down - there might be hot water in the reservoir. 14. To avoid a circuit overload, do not operate an iron on the same circuit with another high-wattage appliance. 15. Ban extension cord is absolutely necessary, a cord with an ampere rating equal to or greater than the maximum rating of the iron shall be used. A cord rated for less amperage can result in a risk of fire or electric shock due to overheating. Care shall be taken to arrange the cord so that it cannot be pulled or be tripped over. Save these instructions. Care and Cleaning: Iron: 1. Turn temperature control dial to off/O. Unplug and let cool. 2. Drain water and secure cord. 3. Store in an upright position. Soleplate: 1. Never iron over zippers, pins, metal rivets, or snaps, since these may scratch the soleplate. 2. To clean buildup on soleplate, wipe with a sudsy cloth. Do not use abrasive cleansers or metal scouring pads. Please Note: You may see water droplets inside the water tank of your new iron. This is because each of our irons is factory-tested to ensure quality product performance.
Description
Parts and Features: 1. Spray nozzle 2. Water fill door 3. Steam switch 4. Spray and steam burst buttons 5. Soft touch grip 6. Cord retraction button 7. Heel rest 8. Temperature control dial 9. Self-clean button 10. Soleplate. 11. Retractable cord.Other Description
For questions and other information: hamiltonbeach.com. hamiltonbeach.ca. hamiltonbeach.com.mx. USA: 1.800.851.8900. Canada: 1.800.267.2826. Mexico: 01 800 71 16 100. If you have any questions, please contact our customer service: USA 1-800-851-8900. Canada 1-800-267-2826.Warnings
Not ApplicableUPC
040094142903