1. Home
  3. Paslode Staples 9000 ea BOX

Paslode Staples 9000 ea BOX

On This Page

 

Directions

Heavy duty staple & nailer operator safety instructions. While paslode has designed, produced and inspected all its tools with safety in mind, there are certain basic safety precautions precautions that should always be taken by the operator. These include: (1) Never operate or work in the vicinity of a tool in use without hearing and eye protection devices, including side shields. (2) Never assume the tool is empty. Check the magazine. (3) Never engage in horseplay with the tool, it is not a toy. (4) Never point the tool at anyone or yourself, even if you think it is empty or disconnected. (5) Never operate the tool unless it is in contact with the work piece. (6) Never tamper with, disable, or remove the work contact element. (7) Never leave the work area for any extended period of time without disconnecting the tool from the air line. (8) Never attempt to clear a jam without disconnecting the tool from the air line and removing the remaining fasteners from the tool. (9) Never allow the air pressure to exceed the maximum marked on the tool. Check the air pressure gauge at least twice daily. Do not operate with bottled air or gases (10) Never operate a dirty tool: Clean the tool at least daily and lubricate. If required. (11) In case of tool malfunction: (a) Disconnect from air line immediately and remove all fasteners from magazine. (b) Turn the tool over immediately to the person responsible for repair, or a attach a tag to the air inlet indicating the tool should not be used. (c) Never re-connect to the air line until the tool is thoroughly repaired and inspected. (12) Never carry the tool with the trigger depressed. (13) Never clamp the trigger in a locked operating position. (14) Never load the tool with either the trigger or work contact element depressed. (15) Never use parts or fasteners other than those specifically designed and recommended by Paslode for use in the tool and the work to be done. (16) Never attempt to modify the tool in any way. (17) For detailed information on the tool installation, maintenance and loading Instructions, refer to the tool owners manual. (18) Treat the tool with respect and it will perform safely and reliably for you. For best perfomance use only genuine Paslode Staples.

 

Description

1-3/4 Inches. 16 Gauge. For model(s). S200-S16, 900078NT. East to Drive!. Less Jamiming!. Advanced chisel point design!.

Other Description

ISANTA Member.

Warnings

Not Applicable

UPC

00759501003934