Mag 1 Carb & Choke Cleaner 11 oz AEROSOL
On This Page
Directions
General: Except as directed below. shut off engine while spraying product under the hood. For pinpoint application. insert extension tube firmly into hole in spray button. Hold can upright and press firmly on spray button to apply product. If sprayed on paint or plastic, flush immediately with water to avoid damage by the strong solvents in this product Carburetors, Chokes & Linkages: Remove air cleaner. Spray and flush exterior surface of carburetor and linkages, and allow to dry. When dry, start engine and spray short bursts into carburetor throat, flushing automatic choke valve and throttle (butterfly) plates. If engine stalls, stop spraying and restart it. Increase engine speed slightly until all liquid is drawn off, then replace air cleaner. PVC Valves: Disconnect crankcase side of PCV valve. Insert extension tube into open end of valve unit and spray a small amount of product inside. Shake unit several time to make sure check valve is loose. Start engine and again spray into valve several times to completely flush it out. Reconnect PCV valve.
Description
Evolutionary performance. Quickly removes gum & varnish. For use in 2 and 4 cycle engines to remove gum, varnish and deposits from carburetor to improve performance and maximize efficiency.Ingredients
Contains: Heptane (Cas 142-892-5); Acetone (Cas 67-64-1); Isopropyl Alcohol (Cas 67-63-0); Naphtha (Petroleum) Light Aromatic (Cas 64742-95-6).Warnings
Danger! Extremely flammable. Vapor may be harmful if inhaled. May be harmful or fatal if swallowed. Contents under pressure. Read carefully the directions for use and other precautions on back panel.Distributor
Warren Distribution, Inc.800-825-1235
mag1.com
UPC
071621004142