1. Home
  2. Cycles Replacement Parts
  3. Bell Light Set 1 ea CARD

Bell Light Set 1 ea CARD

On This Page

 

Directions

Headlight: To install headlight: Place on handlebar. Wrap silicone strap around bar as tightly as possible. Latch to hook. To recharge light: Remove light from bicycle. Plug small side of included usb cable into back of light and the large end into your computer or any other powered USB outlet. The indicator light will flash red while charging and change to green when charging is completed. Charge completely before first use. Tail light bracket. Tail Light: To install tail light: Place mount on seatpost at desired position. Wrap silicon strap on seatpost and hook in place. Putting your tail light in the bracket. Clip fixation clip. Tail light: Align clip on tail light with slot in bracket and slide into place until it clicks. To release: Pull clip gently away from the light and side upwards until clear. Batteries. To install batteries: On the bottom of the light there is a slot. Use a small coin to pop the lens off, exposing the battery housing. Tail light uses 2-AA batteries included.

 

Description

Hi-lumen. Rechargeable. See and be seen lights. Battery charge fuel gauge. 240 lumens! Headlight recharges. Distance: 68 m; 240-120 lumens; 1.5-9 hours. 3 m; 10 lumens; 45-120 hours. Fuel Gauge: Green 100-75%; Orange 75-25%; Red less than 25%. 1 focused narrow beam; 2 diffused wide beam. Includes: One (1) headlight, one (1) tail light, mounting hardware.

Warnings

Not Applicable

UPC

035011975580