Craftsman Feed Spool 1 ea BLISTER PACK
On This Page
Directions
To replace or rewind the spool or clear a jam: 1. Disconnect the power source. 2. Release tabs as shown in Fig 1. to remove the cover and spring. 3. Clear any broken line or debris and replace or rewind spool. 4. Insert the line and end through the eyelet in the spool hub as shown in Fig. 2. Maintain tension by pulling the line through, the hole while placing the spool into the hub arrow side up. See Fig. 3. 5. Press the spool down and rotate it until it drops into place. When in place, the spool will turn a few degrees left and right freely. 6. Snap spool cap into place. Connect power source and turn the tool on. You will hear the nylon line being cut automatically to the proper length.
Description
0.065 in diameter rounded line. Factory wound. For smooth, reliable operation. Fits Trimmers: CMCST98020; CMESTA900; CMESTE920.Other Description
To Join Craftsman Club: www.craftsman.com/signup.Warnings
Caution: Always wear proper eye protection. Unplug tool before changing, installing, or removing accessories. Read tool operator's manual for additional safety precautions before using this accessory.UPC
00885911558457