ACE Straight Valve 1 ea BLISTER PACK


 

Directions

1. Turn off water supply leading to work area. 2. Open faucet or flush toilet to remove water existing in line. 3. Remove old valve and any old solder or compression nut/sleeve. 4. Slide flange over copper stub-out. 5. Slide compression nut followed by the sleeve onto stub-out. 6. Place shut off valve onto stub-out. Tighten compression nut to valve. Required torque is approximately 1/2 turn after the nut begins to take hold or bite into tube. 7. Position valve outlet to receive supply line or tube and attach to valve. 8. Turn on water to work area and test installation before leaving job site.

 

Description

Outlet: 1/2 inch OD. Inlet: 5/8 inch OD (1/2 inch Nom). Quality since 1924. Corrosion resistant brass ball. This product contains less than 0.25% weighted average lead content on wet surfaces.

Warnings

Cancer and reproductive harm - www.P65Warnings.ca.gov.

UPC

00082901247098