Keeney Valve 1 ea BLISTER PACK
On This Page
Directions
Required Installation Instructions: 1. Turn off water supply leading to work area. 2. Open faucet or flush toilet to remove water existing in line. 3. Remove old valve and any old solder or compression nut/sleeve. 4. Slide flange over copper stub-out. 5. Slide compression nut followed by the sleeve onto stub out. 6. Place shut off valve onto stub-out. Tighten compression nut to valve. Required torque is approximately 1/2 turn after the nut begins to take hold or bite into tube. 7. Position valve outlets to receive supply lines or tubes and attach to valve. 8. Turn on water to work area and test installation before leaving job site.
Description
Inlet: 1/2 in. Outlet: 3/8 in. Shut-of water independently to two different fixtures. Premium quality. Corrosion resistant brass ball. Connects to copper. Lead Free: The wetted surface of this product contacted by consumable water contains less than one quarter of one percent (0.25) of lead by weight.Warnings
This product can expose you to chemicals including lead which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.UPC
00046224047742