Tungsram Nighthawk Bulb
1 bulb
On This Page
Directions
Installation Instructions: 1. Check your vehicle owner's manual for special instructions. 2. Remove any outer trim to obtain access to headlamp assembly. 3. Identify and remove the four retaining ring crews. These are smaller than the two aim adjustment screws. Do not disturb aiming screws. Remove the retaining ring. 4. Pull the headlamp forward, disconnect the plug and dispose of the old headlamp carefully. 5. Plug in the new Halogen headlight. Position it back into the lamp cavity right side up, ensuring locating tabs of bulb are fitted in positioning slots. Replace the retaining ring and trim. 6. Check for proper headlamp aim. Aim Check: (35-40 Feet of flat surface required) 1. Shine low beams on garage door from 2-3 feet away and outline the bright spots on the door with pencil or tape. 2. Back the car to about 25 feet from the door. The top of the low beams should shine no higher than the top of the marks on the door, or lower than the center of the marked circle. Tip: To raise the beam turn the top adjustment screw clockwise and counter-clockwise to lower it. Turn the side adjustment screw clockwise to move beam right and counter-clockwise to move left. Tip: After adjusting, lightly turn adjusting screws clockwise so headlamp will be held against tension spring.
Product Details
(2A1) 12 volts. 4 headlamp system. Bright (). Brilliant (). Far; Wide. tungsram.com. Made in China.Nutrition Facts
Warnings
Replace individually or in pairs for best performance. Warning: Pressured lamp - unexpected rupture may cause injury, fire, or property damage. Do not use lamp if outer glass is scratched or broken. Dispose of lamp in a closed container.Manufacturer
Tungsram
Vaci ut 77 Budapest H-1004 Hungary
UPC
05994100045113