Elmer's Multi-Purpose Spray Adhesive
On This Page
Directions
Not recommended for use on vinyl materials or automotive headliners. Preparation: Shake can well before using. Protect surrounding area from overspray (dried adhesive will remain slightly tacky). Point spray button opening away from you with can 6 to 8 inches from surface to be bonded. Spray an even coat. Important! To avoid possible clogging, turn the can upside down and spray a short jet of clear gas after completing job. Application: For temporary bonds: spray a light coat and allow to dry for 3-5 minutes before joining. To remove, work a corner loose and peel back. For permanent bonds: Join surfaces within 15 seconds while adhesive is still tacky. Allow to set at least one hour. Note: Do not use for bonding heavy materials.
Description
Elmer's® Multi-Purpose Spray Adhesive. Allows for repositioning. Dries permanent. Fast tack, dries clear. Resists "blend through". Acid free, photo safe. With wide pad nozzle for no-mess application.Other Description
Carb category: mist spray adhesive. VOC content is less than 65% by weight. No lead in formula; no fluorocarbons; no methylene chloride; no hexane; no methoxy or ethoxyethanol or their acetates. Art & creative materials institute certified. Conforms to ASTM D 4236. Spray adhesive great for: Photos. Fabrics. Paper. Glass. Foil. Cork. Metal. Plastics. Wood. Films. Felt. Cardboard. Canvas. Leather. Rubber. Foams. Uses: Elmer's "fast tack" spray adhesive is a strong, water-resistant adhesive which provides a permanent or temporary bond on a wide variety of materials. Will not swell or warp. Resists "bleed-through." This product was manufactured for and intended for consumer use. It is labeled according to the federal hazardous substances act. Should product be used in the workplace, material safety data sheets may be obtained at www.elmers.com. ©2009. www.elmers.com. ACMI CL®.Warnings
Danger: Extremely flammable. Contents under pressure. Vapor harmful. Eye irritant.Danger: extremely flammable. Contents under pressure. Vapor harmful. Eye irritant. Contains: Acetone. Do not puncture or incinerate or expose to temperatures above 120 degrees F (50 degrees C).
Precautions: Do not smoke when using. Keep away from eyes. Avoid contact with heat, sparks and open flame. Vapors can ignite explosively. If using indoors turn off all pilot lights. Do not store or use near heat or flame.
Keep out of reach of children. Use only with adequate ventilation.
First aid treatment: if eye contact occurs, rinse with tap water for 5-10 minutes. If irritation persists, see medical care. If inhalation symptoms occur, move to fresh air. If symptoms persist, see a physician.
For further health information contact a Poison Control Center or call 1-888-516-2502.
Distributor
Elmer's Products IncColumbus, OH 43219
www.elmers.com
UPC
00026000004527