Schwinn Bike Helmet, Lighted, Beam, Adult
1 helmet
On This Page
Directions
Fitting Instructions: Position helmet to sit level on your head. The front should sit one finger-width above your eyebrows. Turn the rear dial for a snug fit. Adjust the side strap clasps to hit just below your ears, forming a V shape. Buckle the chin strap. Tighten so that no more than one finger fits under strap. Battery Replacement: 1. Push down the latch on the inside of the helmet cage to release light. 2. Pull light out of cage. 3. Use a screwdriver to open battery case. 4. Slide CR2032 batteries into slots. 5. Close battery cover and clip light back into helmet. Light Operation: 1. Press black button on the light to turn on. Press once to turn on for steady mode, twice for flash, three times to turn off.
Product Details
Ages 14+ adult. Includes : One helmet. Battery Included: Two CR2032 catteries. Schwin quality. High visibility. Easy adjust dial fit 360 degrees comfort. Light it up! Take a flash photo. Reflective. Reflective Material: High visibility when riding at night. Removable Rear Light: Steady and flashing modes. Maximum Ventilation: Maximum air circulation to keep you cool. Removable Visor: Reduced glare and provides protection. Full-coverage interior padding. Easy-adjust dial fit. Safety CPSC Standard. Complies with US CPSC safety standard for bicycle helmets for persons age 5 and older. www.schwinnbikes.com. Twitter. Facebook. For customer service inquiries: Toll Free: (800) 515-0074. Reduce, reuse, recycle, repeat. Made in China.Nutrition Facts
Warnings
This product may contain chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm.,Read instructions manual. A helmet cannot always protect against injury. This helmet must be fitted and attached properly to the wearer's head according to the fitting instructions described in the manual. For maximum protection the helmet must be fitted and attached properly to the wearer's head in accordance with manufacturer's fitting instructions. No protective headgear can protect the wearer from all possible impacts. Even at very low speeds, accidents can result in serious injury or death. However, for maximum protection this helmet must fit snugly. The chinstrap must fit firmly against the throat, and the buckle must be fastened securely (for further fitting instructions see enclosed instructions). This helmet can be seriously damaged by some common substances (for example: certain solvents like ammonia, certain cleaners such as bleach, etc.) without visible damage. Apply only mild soap and water to clean (for further cleaning and care information see enclosed instructions or call (800) 515-0074). Make no modifications to this helmet. This helmet is not for motor vehicle use. Do not wear a helmet that has been involved in an accident. Even if you cannot see any damage, The helmet can be damaged to the point that it would no longer provide adequate protection. If such an impact occurs the helmet should be returned to the manufacturer for component inspection or should be destroyed and replaced.Manufacturer
PACIFIC CYCLE
4902 Hammersley Road Madison, WI 53711
UPC
00038675146204