Command Razor Holder, Bath
1 package
On This Page
Directions
Apply: 1. Choose a location where strips are not over grout lines. 2. Clean surface with rubbing alcohol. Do not use household cleaners. 3. Remove blue liner. Press adhesive to razor holder. 4. Remove black liner. Press to wall for 10 seconds. 5. To ensure adhesive hold, slide razor holder up and off. 6. Press base firmly for 30 seconds. 7. Slide razor holder on to mounting base. 8. Wait 1 hour before use. Remove: 1. Slide razor holder up and off. 2. Gently hold mounting base in place. 3. Never pull the strip towards you! Always pull straight down. 4. Stretch the strip slowly against the wall at least 12 inches to release. Razor holder can be reused with Command Bath Medium Refill Strips.
Product Details
Holds 3 lb (1.3 kg). Bath16-ES. Damage-free hanging. Holds strongly. Removes cleanly. Proven to hold better than suction cups. Water resistant strips. Limited Warranty and Limitation of Liability (for product sold in USA): This product will be free from manufacturing defects. If defective, your exclusive remedy shall be, at 3M's option, product replacement or refund. 3M will not be liable for any loss or damage arising from this product, whether direct, indirect, special, incidental or consequential. command.com. Holder made in Mexico. Strips made in USA.Nutrition Facts
Warnings
Failure to follow instructions carefully may cause damage. Save instructions or visit command.com. Caution: Do not hang over beds or on wallpaper. Do not hang valuable or irreplaceable items or framed pictures. Apply and use 15 degrees - 125 degrees F.Manufacturer
3M
St. Paul, MN 55144
UPC
00051141958378