Permatex Gasket Maker, Ultra Grey
80 ml
On This Page
Directions
Directions: 1. For best results, surfaces should be clean and dry. 2. Cut nozzle and apply a continuous 2 to 6 mm (1/16 in to 1/4 in) bead of silicone to one surface, surrounding all bolt holes. Assemble parts immediately while silicone is still wet. Finger tighten until material begins to squeeze out around flange. 3. Let dry for one hour then tighten to torque specifications. 4. Allow 24 hours to fully cure before filling with fluids or returning to service. 5. Replace cap after use. Note: Not recommended for use on head gaskets or parts in contact with gasoline.
Product Details
High torque & vibration resistance. Ideal for cast metal parts. Sensor safe RTV silicone. Meets OEM specs. Ultra Grey Gasket Maker is a premium choice for cast metal parts with rigid joints that experience high torque loads. For rigid joints and high torque. Sensor safe. Non-corrosive. Temp Range: -65 degrees F to 450 degrees F (-54 degrees C to 232 degrees C) continuous, 50 degrees F (260 degrees C) intermittent. Applications: Valve covers, oils pans, intake manifold end seals, timing covers, water pumps, thermostat housings. www.permatex.ca. Assembled in U.S.A. with US and global materials.Nutrition Facts
Warnings
Caution: Irritant.,Caution: May irritate eyes. May irritate skin. Do not get in eyes. Do not get on skin or clothing. Do not breathe fumes. Keep out of reach of children.,First Aid Treatment: Contains polydimethylsiloxane, calcium carbonate, If swallowed, call a Poison Control Centre or doctor immediately. Do not induce vomiting. If in eyes, rinse with water for 15 minutes. If on skin, rinse well with water.Manufacturer
ITW Global Brands
Oakville, ON
UPC
00068161599030