Permatex Epoxy, 500 Degrees
25 ml
On This Page
Directions
Directions: 1. For best results roughen surfaces using an abrasive or sandpaper. Surfaces must be clean, dry and free of grease and oil. 2. Remove plastic mixing paddle from center of black plunger. Turn nozzle end up and snap off storage cap (save cap). Pull plunger back 3 mm (1/8 in). Allow air bubbles to rise to top. 3. When ready, push plunger evenly to dispense equal amounts of hardener and resin onto a discardable surface (a piece of cardboard or the plastic package). Pull back plunger to stop. 4. Mix thoroughly with the paddle. 5. Apply to surfaces. Adhesive will start to set in 30 minutes and achieve fixture strength in 1 hour. Full cure in 24 hours. 6. Wipe nozzle clean. Replace cap for storage. Note: Will not bond to polyethylene or polypropylene plastics.
Product Details
High heat. 10 min. set time. 120 min. cure time. Up to 2500 psi. Under hood & automotive applications. Chemical resistant. Bonds: Metals, hard plastics, glass, rubber & more. A 2-part general purpose epoxy that can withstand intermittent temperatures up to 500 degrees F and is the perfect solution for auto mechanics, home heating contractors or any home/auto applications. Sets in 10 minutes. Cures in 120 minutes. Temp Range: -51 degrees C to 260 degrees C (-60 degrees F to 500 degrees F). Finished Colour: Amber. Chemical resistant. Permanent strength up to 2500 psi. www.permatex.ca. Assembled in U.S.A. with U.S. and global materials.Nutrition Facts
Warnings
Caution: Irritant.,First Aid Treatment: Contains diglycidyl bisphenol A ether. If swallowed, call a Poison Control Centre or doctor immediately. Do not induce vomiting. If in eyes, rinse with water for 15 minutes. If on skin, rinse well with water.,May irritate eyes. May irritate skin. Do not mix with other chemicals. Do not get in eyes. Do not get on skin or clothing. Keep out of reach of children.Manufacturer
ITW Global Brands
Oakville, ON
UPC
00068161841184