Camco RV Water Heater Anode Rod, 9.5 Inch
1 package
On This Page
Directions
Installation Instructions: (1) Turn the water heater's gas regulator to the OFF position (2) Allow water in the heater tank to cool, or open a hot water faucet inside the RV until water temperature is cool. (3) Turn off the water supply. (4) Open a hot water faucet or T & P valve to release line pressure. (5) Remove the drain plug of the water heater tank. Older models may have a square head drain plug. (6) Apply teflon tape to Camco’s RV Anode Rod. Wrap 3 to 5 layers only in the same direction that you tighten the rod. (7) Insert Anode Rod and tighten until snug. Use caution. Do not overtighten. Use only 7-8 ft-lbs torque. (8) Turn on water supply to RV. While filling the hot water heater, open the hot water faucets inside the RV. Allow water to run until all air is forced from water lines, then close the faucets. Water heater should now be full, (9) Examine the RV Anode Rod for leaks and tighten if necessary. Camco recommends inspecting your anode rod monthly. Over time, minerals can build up around the drain plug opening making removal of your anode rod difficult, and frequent inspection will help prevent this. For maximum performance, replace your RV Anode Rod when less than one half of the rod remains.
Product Details
Aluminum 3/4 inch NPT for Morflo / suburban water heaters. Extend the life of your RV's water heater with Camco's anode rods for water heaters. Camco's RV Anode Rods preserve the life of your water heater by corroding so your water heater tank doesn't. Simply replace your drain plug with a Camco RV Anode Rod to protect your tank. www.camco.net. Made in Vietnam.Nutrition Facts
Manufacturer
Camco Manufacturing, Inc.
121 Landmark Dr. Greensboro, NC 27409
UPC
00014717115636